Panel Controls And Functions (Main Panel); Front Panel - Steinberg AXR4T Operation Manual

Panel Controls and Functions (Main Panel)

Front Panel

1
1 MIC/LINE/HI-Z [1]/[2] jacks
For connecting to a microphone, digital
instrument, electric guitar, or electric bass.
This jack can be connected to both XLR-
type and 1/4" phone-type plugs. Both
balanced and unbalanced connections
are supported when using a 1/4" phone-
type LINE connection. Unbalanced
connection is supported when using a
1/4" phone-type HI-Z connection.
2 MIC/LINE [3]/[4] jacks
For connecting to a microphone or digital
instrument. This jack can be connected to
both XLR-type and 1/4" phone-type plugs.
The XLR-type plug is dedicated for
microphone connection plug. Both
balanced and unbalanced connections
are supported when using a 1/4" phone-
type LINE connection.
3 [SEL] keys
Dedicated selection keys to switch
between MIC/LINE/HI-Z [1]/[2], and MIC/
LINE [3]/[4]. The ANALOG SETUP screen
for the selected channel appears on the $
display. This lights up green when
selected.
You can turn channel linking on and off by holding
down a [SEL] key for MIC/LINE/HI-Z [1]/[2] or MIC/
LINE [3]/[4] and pressing the other [SEL] key
(page 12). The channel that was pressed first lights
up in green. The channel pressed afterwards flashes
in green. The ANALOG SETUP screen for the
channel flashing in green appears on the display.
Press the [SEL] key on the side that is flashing in
green to switch the channel selection to the side
pressed.
3 6
4 2
Panel Controls and Functions (Main Panel)
5 8 9 ! @ $
7 ) #
4 [+48V] indicators
Lights up in red when the phantom power
is turned on.
NOTICE
When connecting devices or when switching
the routing structure, observe the following
cautions to avoid damage and noise being
introduced to the product and peripheral
devices.
• Turn the phantom power off
connecting a device that does not support
phantom power to the MIC/LINE/HI-Z [1]/[2]
jack or the MIC/LINE [3]/[4] jack.
• Do not connect or disconnect cables to/from
the MIC/LINE/HI-Z [1]/[2] jacks or the MIC/LINE
[3]/[4] jacks while the phantom power is on.
The [+48V] indicator flashes for several
seconds when phantom power is turned off.
Wait until this indicator stops flashing before
plugging in or taking out cables.
• Turn the phantom power on and off when the
[MUTE] key on the front of the AXR4 device is
on.
• HI-Z and phantom power cannot be turned on
at the same time.
% ^ *
&
(page 23) when
AXR4 Operation Manual 4