Steinberg AXR4T Operation Manual page 15

DIGITAL I/O MODE screen
This screen is used to set whether to use the
connector in S/PDIF format or ADAT format
when using the OPTICAL A [IN]/[OUT]
connector. Further, you can set whether the
[AES/EBU] connector or the OPTICAL B [IN]/
[OUT] connector is used, and if the OPTICAL
B [IN]/[OUT] connector is used, you can set
whether to use the connector in S/PDIF format
or ADAT format.
The three options available are ADAT, S/PDIF,
and AES/EBU (DIGITAL(B) only).
How to configure the DIGITAL I/O MODE
1.
On the SYSTEM SETUP screen, turn the
multi-function knob to select "DIGITAL I/O
MODE."
2.
Press the multi-function knob to select.
3.
When the DIGITAL I/O MODE screen
appears, turn the multi-function knob to
select either "DIGITAL(A)" or "DIGITAL(B)."
4.
Press the multi-function knob to select.
5.
When the DIGITAL(A) or DIGITAL(B)
screen appears, turn the multi-function
knob to select a format.
6.
Press the multi-function knob to confirm.
Panel Controls and Functions (Main Panel)
PEAK HOLD screen
This screen sets the peak level display for the
level meter on or off.
How to open the PEAK HOLD screen
1.
On the SYSTEM SETUP screen, turn the
multi-function knob to select "PEAK
HOLD."
2.
Press the multi-function knob to confirm.
How to use the PEAK HOLD screen
1.
Press the multi-function knob to display the
settings dialog.
2.
Turn the multi-function knob to select either
"ON" or "OFF."
3.
Press the multi-function knob to confirm.
AXR4 Operation Manual 15