Steinberg AXR4T Operation Manual page 54

Configuring settings on the DAW
7.
Set the output from the DAW to the AXR4.
Configuring settings on the Mixer
window
8.
Set MIC 1 channel settings (gain, phantom
power, high pass filter, effects, etc.).
9.
Turn the LINE 1/2 output headphone 1 on.
10.
Set the MIC 1 channel and DAW channel mix
bus (send destination) to LINE 1/2.
11.
Adjust MIC 1 channel faders, DAW channel
faders, LINE 1/2 output faders and the
headphone 1 knob controls to create a mix
balance to be used by the sound engineer.
dspMixFx AXR changes the input channels
displayed based on the mix bus (send destination)
selection made here. Check that the currently
selected mix bus (send destination) is the one
intended for use before controlling input channels.
12.
Turn the LINE 3/4 output headphone 2 on.
Panel Controls and Functions (Software)
13.
Set the MIC 1 channel and DAW channel mix
bus (send destination) to LINE 3/4.
14.
Adjust MIC 1 channel faders, DAW channel
faders, LINE 3/4 output faders and the
headphone 2 knob controls to create a mix
balance to be used by the sound engineer.
TIPS
If the vocalist makes requests about specific
parts in the audio, return to the DAW to
make the necessary changes. Some DAWs
allow a vocal-specific monitor mix to be set
separate from the original mix.
When using Cubase, this can be achieved
by combining studio functions, audio
connections and the Mix Console. For more
information, see the Cubase Operation
Manual.
AXR4 Operation Manual 54