Steinberg AXR4T Operation Manual page 23

• PAD
How to configure
1.
On the ANALOG SETUP (MIC) screen, turn
the multi-function knob to select "PAD."
2.
Press the multi-function knob to select.
3.
When the dialog appears, turn the multi-
function knob to select either "ON" or
"OFF."
4.
Press the multi-function knob to confirm.
Attenuation when PAD is on is 20(dB).
Panel Controls and Functions (Main Panel)
• +48V
NOTICE
When connecting devices or when switching the
routing structure, observe the following cautions to
avoid damage and noise being introduced to the
product and peripheral devices.
• Turn the phantom power off when connecting a
device that does not support phantom power to
the MIC/LINE/HI-Z [1]/[2] jack or the MIC/LINE [3]/
[4] jack.
• Do not connect or disconnect cables to/from the
MIC/LINE/HI-Z [1]/[2] jacks or the MIC/LINE [3]/[4]
jacks while the phantom power is on. The [+48V]
indicator will flash for several seconds when
phantom power is turned off. Wait until this
indicator stops flashing before plugging in or
taking out cables.
• Turn the phantom power on and off when the
[MUTE] key on the front of the AXR4 device is on.
• HI-Z and phantom power cannot be turned on at
the same time.
How to configure
1.
On the ANALOG SETUP (MIC) screen, turn
the multi-function knob to select "+48V."
2.
Press the multi-function knob to select.
3.
When the dialog appears, turn the multi-
function knob to select either "ON" or
"OFF."
4.
Press the multi-function knob to confirm.
AXR4 Operation Manual 23