Steinberg AXR4T Operation Manual page 51

4 Knob Mouse Control
Used to select the means of controlling
dspMixFx AXR knobs with the mouse.
The relationship between each setting and the
corresponding knob action is described below.
Setting Knob control method
Linear Move the mouse left and right as
though drawing a line
Circular Move the mouse left and right as
though drawing an arc
5 Peak Hold
Turns the peak hold function on and off.
Device Settings
This area is used to configure device-specific
settings. Devices appearing in Device
Settings will change based on interface
changes made in General Settings, and
devices selected on the Mixer window.
1
2
3
4
5
1 Digital A
Used to select the Digital I/O used for
Digital A.
2 Digital B
Used to select the Digital I/O used for
Digital B.
3 HPF
Used to select the frequency of the high
pass filter for analog input from 40 Hz,
60 Hz, 80 Hz, 100 Hz and 120 Hz.
Panel Controls and Functions (Software)
4 Post Fader Send for Reverb
Used to select which mix bus post fader to
send for reverb.
These settings will be applied at once to all mix
buses selected in the Post Fader Send for Reverb
field in relation to all input channels. When "USER" is
selected from the Post Fader Send for Reverb
options, individual settings may be applied using
the following procedure.
1 On the Mixer window, click the "mix bus (send
destination)" option for an input channel, and then
click on a mix bus to select it.
2 While holding down the <control> key, click the
"mix bus (send destination)" option for the same
input channel in step 1, and then click Post Fader
Send for Reverb.
5 Routing Mode
Turns the Matrix Routing on or off.
The relationship between turning Matrix Routing on
and off, and the resulting action, is described below.
Routing Mode Resulting action
status
On Selecting a send destination for
a channel on the Mixer window
will not affect other channels,
allowing different send
destinations to be selected for
each individual channel
Off Selecting a send destination for
a channel on the Mixer window
will set the send destination for
other channels to the same send
destination
AXR4 Operation Manual 51