Steinberg AXR4T Operation Manual page 33

Input Settings area — Head amp
1
3
4
5
6
7
1 [+48V] button
Turns the phantom power on and off.
NOTICE
When connecting devices or when switching
the routing structure, observe the following
cautions to avoid damage and noise being
introduced to the product and peripheral
devices.
• Turn the phantom power off when connecting
a device that does not support phantom
power to the MIC/LINE/HI-Z [1]/[2] jack or the
MIC/LINE [3]/[4] jack.
• Do not connect or disconnect cables to/from
the MIC/LINE/HI-Z [1]/[2] jacks or the MIC/LINE
[3]/[4] jacks while the phantom power is on.
The [+48V] indicator will flash for several
seconds when phantom power is turned off.
Wait until this indicator stops flashing before
plugging in or taking out cables.
• Turn the phantom power on and off when the
[MUTE] key on the front of the AXR4 device is
on.
• HI-Z and phantom power cannot be turned on
at the same time.
2 [PAD] button
Switches the PAD on and off.
3 [HI-Z] button (CH1 and CH2 Only)
Switches the HI-Z on and off.
Attenuation when PAD is on is 20 (dB).
4 Input Gain control knob
Adjusts the input gain.
5 Input Gain value
Used to display and edit the current input
gain.
6 High Pass Filter button
Switches the high pass filter on and off.
7 [ϕ] button
2
• Double click the input gain control knob to minimize
• You can also control the input gain control knob with
• Double click the input gain value to enter a gain value
Input Settings area — Line
1 [+4dBu(20)] button
2 [+4dBu(14)] button
3 [-10dBV] button
4 High Pass Filter button
5 [ϕ] button
Panel Controls and Functions (Software)
Switches phase inversion on and off.
When channels are stereo linked, the
[ϕ] button will appear for both left and right
channels.
input gain.
the mouse wheel.
directly.
1
2
3
4
5
Sets the required input level to +4 dBu
(20).
Sets the required input level to +4 dBu
(14).
The number in the parentheses for +4 dBu (20) and
+4 dBu (14) represents the headroom (dB).
Sets the required input level to -10 dBV.
Switches the high pass filter on and off.
Switches phase inversion on and off.
When channels are stereo linked, the
[ϕ] button will appear for both left and right
channels.
AXR4 Operation Manual 33