Steinberg AXR4T Operation Manual page 61

EQ settings
You can set the EQ on the right side of the
plug-ins panel.
Low band Mid-bands
The following parameters are available.
1 Q
Use the "Q" parameter to set the filter type
when both low and high frequency band
filters are in use. In the low frequency band
filter, two high pass filters and two low
shelving filters are provided. In the high
frequency band filter, two low pass filters
and two high shelving filters are provided.
When in the mid frequency band filter, the
"Q" parameter sets the frequency
response curve width.
2 F
Controls the center frequency of filters in
each frequency band.
3 G
Controls filter gain in each frequency
band.
4 Filter On/Off
The lowermost button switches filters for
the corresponding frequency band on and
off.
5 FLAT
When turning the FLAT button on,
parameters are set as follows.
• Turns the gain for each frequency band
High band
to 0 dB
• Sets low pass filters as low shelving
filters
• Sets high pass filters as high shelving
filters
The section on the upper part of the plug-ins
panel displays the frequency response curve
for all frequency bands.
• To change the filter frequency and gain,
click and drag a point on the curve display.
• To change the Q value, while hold down the
<shift> key, click and drag a curve point.
• Use the zoom controls on the right of the
frequency response curve to zoom in and
out vertically.
Panel Controls and Functions (Software)
AXR4 Operation Manual 61