Input Channels Area - Steinberg AXR4T Operation Manual

Input Channels Area

This area is used to configure input channel
settings. If you are unable to display all
channels due to the window size, use the
scroll bar to display the intended channels.
You can switch between stereo and mono for
all input channels. You can select which
channels to display using filtering settings.
Some functions allow you to select either to
display all details or to show a reduced
display.
1
2
3
4
5
6
1 Channel label
(page
2 Input Settings area
3 SILK
(page 34)
4 Insert FX
(page 34)
5 Reverb Send
(page
6 PAN/FADER area
• In the input channels area and the output channels
area, you can select to display all functions (Display
All) or to display designated functions only (Reduced
Display) (page 39).
• Not all channels will be displayed in the input channels
area on the initial window shown when launching
dspMixFx AXR. Either move the display using the scroll
bar, or increase the window width to display hidden
channels.
32)
34)
(page 37)
Panel Controls and Functions (Software)
Channel label
*Red box section
This displays the channel name. Double click
this to rename the channel name. Channel
labels can be up to eight characters long.
While holding down the <control> key, click on
the channel label to display a menu.
Channel name
Click this to reset the channel name back to its
initial setting.
Channel Link
Click this on a mono channel to link the
channel to the adjacent channel. Click this on
a stereo channel to convert a stereo channel
into two mono channels. A tick will appear to
indicate linked channels.
AXR4 Operation Manual 32