Panel Controls And Terminals (Details); Rear Panel - Steinberg UR28M Operation Manual

Panel Controls and
Terminals (Details)

Rear Panel

DC IN 12V
For connection to the AC power adaptor.
Grounding screw
For connection to a ground wire.
If you have a problem with hum or noise, use this
terminal to connect to ground. The noise may be
reduced.
2TR IN (3.5 mm, stereo)
For connection to a portable audio player.
The input signal at 2TR IN flows only to MIX 1
(page 33), and not to the computer.
USB2.0 (USB port)
For connection to a computer or iPad. Apple iPad
Camera Connection Kit or Lightning to USB
Camera Adapter are required when connecting
the UR28M with an iPad.
USB Port Precautions
NOTICE
Be sure to observe the following points when
connecting to the computer's USB interface.
Failing to do so may result in the computer freezing
or shutting down, as well as corruption or even
loss of data. If the device or computer does freeze,
restart the application or computer.
• Be sure to wake the computer from sleep/
suspended/stand by mode before making a
connection to the computer's USB port.
• Before turning on the power to the device,
connect the computer to the USB port.
• Before turning on/off the device or plugging/
unplugging the USB cable, quit any open
application software on the computer.
• When connecting or disconnecting the USB
cable, be sure to set all output level controls to
the minimum.
• Wait at least six seconds between connecting or
disconnecting the USB cable.

Panel Controls and Terminals (Details)

S/PDIF IN/OUT (coaxial)
For connection to a digital audio device.
S/PDIF OUT outputs one of the MIX 1–3 and DAW
OUT signals. To select the output signal, use the
"Setup Window" (page 16) in the section
"dspMixFx UR28M" or the "Output Routing
Window" (page 20) in the section "Dedicated
Windows for Cubase Series".
S/PDIF IN is equipped with the SRC (Sampling
Rate Converter) function. Even if the sampling
rate at which the device is operating differs from
the sampling rate of the audio signal input to the
S/PDIF IN, the SRC function will automatically
convert the rate so that playback will be correct.
SRC is only available when INTERNAL is selected
as the clock source of the device. To select the
clock source of the device, use the "(device
name) Window" (page 10) in the section "Control
Panel of the Audio Driver" in Windows or Audio
MIDI Setup in Mac.
PHONES 1/2 (phone type, stereo)
For connection to a set of headphones.
PHONES 1 outputs the MIX 1 signal. PHONE 2
outputs one of the MIX 1–3 signals. To select the
output signal of PHONES 2, use the "Headphone
Area" (page 15) in the section "dspMixFx
UR28M" or the "Headphones Window" (page 20)
in the section "Dedicated Windows for Cubase
Series."
UR28M
Operation Manual 5