Figure 80. C445Uc-N2: Nema Status Only; Figure 81. C445Uc-N5: Nema Control And Status - Eaton Power Xpert C445 User Manual

Figure 80. C445UC-N2: NEMA Status Only

Figure 81. C445UC-N5: NEMA Control and Status

Overlay Display:
OFF LED solid On – Motor is off in "ready" state – no
●
current detected, no faults present
OFF LED blinking On – Motor is off, C445 control is faulted
●
and/or a control inhibit is present
FWD/REV LED solid On – Active RUN command and
●
motor is up to speed – complete start detected
FWD/REV blinking On – Active RUN command but motor
●
is NOT up to speed
AUTO LED Off – C445 control is local source
●
AUTO LED On – C445 control is remote source
●
Power Xpert C445 Global Motor Management Relay MN042003EN—October 2016 www.eaton.com
Chapter 5—System Configuration and Operation
Overlay Buttons:
OFF button – Button press will put the control in "Local"
●
and will send a STOP command to the C445 overload
which will drop out all control outputs and stop the motor.
FWD button – Button press will put the control in "Local"
●
and will send a FWD RUN command to the C445 overload
to enable the forward output relay (Q1).
REV button – Button press will put the control in "Local"
●
and will send a REV RUN command to the C445 overload
to enable the reverse output relay (Q2).
AUTO button – Selects the remote source as the active
●
C445 control
RESET button – Resets fault if condition has cleared
●
77