Table of Contents
Related Manuals for Eaton Cuttler-Hammer Addressable Relay II
Summary of Contents for Eaton Cuttler-Hammer Addressable Relay II
- Page 1 INSTRUCTIONS FOR THE INSTRUCTION ADDRESSABLE RELAY II USED IN THE LEAFLET INCOM NETWORKS OF CUTLER-HAMMER IL17435 Rev. C POWERNET SYSTEMS IL17435 Rev. C For more information visit: www.cutler-hammer.eaton.com Effective: 1/05...
-
Page 3: Section 1.0 Communications
They are connected to an INCOM network that is part of and convert them to an RS-232 format for transmission to Eaton’s Cutler-Hammer PowerNet System. A typical the controlling computer. motor starter application is shown in Figure 2. A typical... - Page 4 IL17435 Rev. C Addressable Relay II Page 1-2 Effective Date: 1/05 block, power requirement is 5 VA. dc polarity is not Each Addressable Relay II (see Figure 1) has three hexa- significant. The operating temperature range of the decimal (digits 0 through 9 plus A through F) selector Addressable Relay II is 0 C to 70 switches that must be used to assign a unique address to...
-
Page 5: Wiring Data
Addressable Relay II IL17435 Rev. C Effective Date: 1/05 Page 1-3 TABLE 1 - RELAY CONTACT RATINGS end of the line, place the switch on the end plate in the ON position to terminate the line. Voltage Make Break • Non terminated taps, up to 200 feet in length, off the 120-240 Vac 4960 VA... -
Page 6: Troubleshooting
ARE MADE REGARDING THE INFORMATION, RECOM- MENDATIONS AND DESCRIPTIONS CONTAINED HEREIN. 9.0 TROUBLESHOOTING In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental or... - Page 7 Addressable Relay II IL17435 Rev. C Effective Date: 1/05 Page 1-5 Effective Date: 1/05 For more information visit: www.eatonelectrical.com Page 1-5...
- Page 8 Eaton has 55,000 employees and sells products to customers in more than 100 countries. For more information, visit www.eaton.com.
Need help?
Do you have a question about the Cuttler-Hammer Addressable Relay II and is the answer not in the manual?
Questions and answers