Figure 151. 120 Vac Inputs And 120/230 Vac Outputs/C445 Power - Eaton Power Xpert C445 User Manual

Chapter 5—System Configuration and Operation

Figure 151. 120 Vac Inputs and 120/230 Vac Outputs/C445 Power

L1
L2
L3
PE
Q1
Q11
MOTOR
3~
Notes:
1. The inputs on the Base Control Module are only used by
this Operation Mode if Fieldwire is selected for one of
the control sources. If Fieldwire is not the Local or
Remote control source, all 4 inputs may be used as
general purpose inputs or can be selected as the
feedback source for the feeder's aux_on contact.
2. Outputs 2 and 3 may be used as general purpose
outputs for this Operation Mode.
3. If Fieldwire is the Local control source, Input 3 is the
Remote input. When power is applied to Input 3, the
C445 will be in Remote mode.
4. If Fieldwire is the Remote control source and 2-wire
control (default) is selected, Inputs 2 and 3 are unused
by this operation mode. Either may be used as the
feedback source for the feeder's aux_on contact.
5. Fusing: Although C445 product listings do not require
fusing on the high impedance line voltage measurement
inputs, it may be necessary to provide overcurrent
protection of the supply leads in accordance with
applicable final installation specific local, state and
national electrical codes.
6. C445UC... control user interfaces offer 4 additional
24 Vdc digital inputs for general purpose use. An input
can also be used as the feedback source for the feeder's
aux_on contact.
116 Power Xpert C445 Global Motor Management Relay MN042003EN—October 2016 www.eaton.com
C445U...
CH2
CH1
V1 V2 V3
C445M...
CH2
CH1 CH1
T1 T2 I1 I2
PTC
C445BA-SA...
I3 I4 IC IC IC Q1 Q1 Q2 Q2
Q11
C D0 D1
Optional Modbus
Q3 C Q3 PE N L
FB1
FERRITE
(+) Us
120/240 VAC
(-) Us
(+) Uc
(-) Uc
120 VAC