Setting Time; Setting Ratios; Setting Wires; Setting Pulse Output - ABB A43 User Manual

Meter Settings

4.1.2 Setting Time

To set the time, perform the following steps:

4.1.3 Setting Ratios

To set the ratios, perform the following steps:
Table: 4:1
Option
Transformer Current (CT on the dis- 1-9999/1-9
play)
Transformer Voltage (VT on the dis- 1-999999/1-999
play)

4.1.4 Setting Wires

The meter can either use three wires TPE or four wires TPE+N. To set the
number of wires, perform the following steps:

4.1.5 Setting Pulse Output

To set the pulse output, perform the following steps:
A43/A44
User Manual
1. Choose the Settings icon in the main menu, press
2. Choose "Clock", press
3. The display will now show the date. Press
4. Set the time.
1. Choose the Settings icon in the main menu, press
2. Choose "Ratios", press
3. The display will show the quantity Current (CT on the display) and the
ratio. To change the ratio, press
4. Press . The display will show the quantity Voltage (VT on the display)
and the ratio. To change the ratio, press
1. Choose the Settings icon in the main menu, press
2. Choose "Wires", press
3. The display will now show the wire configuration used by the meter.
4. Set the number of wires.
1. Choose the Settings icon in the main menu, press
2. Choose "Pulse out" (Pul.out on the display), press
The display will show what type of energy is measured on pulse output 1.
Depending on meter type, the available choices are:
Act.Nrg.Imp on the display
Act.Nrg.Exp on the display
React.Nrg.Imp on the display
React.Nrg.Exp on the display
Inactive on the display
3. Set the energy type.
.
.
. See table 4:1 for interval.
. See table 4:1 for interval.
Interval
.
Active energy imported
Active energy exported
Reactive energy imported
Reactive energy exported
Inactive
34
.
to get to the time-menu.
.
.
.
.
2CMC48001M0201
Revision: C