Setting I/O - ABB A43 User Manual

Meter Settings
Note –
output" when pressing the

4.1.6 Setting I/O

To set the I/O, perform the following steps:
Table: 4:2
I/O
4 configurable I/Os
4 static I/Os
2CMC48001M0201
Revision: C
4. Press once to get to the next menu. The display will show the frequency.
The interval that can be set is 0-999999 imp/kWh or 0-999999 imp/MWh.
Set the frequency and quantity.
5. Press once to get to the next menu. The display will show the
pulse length in milliseconds. The interval for the pulse length is from
10 to 990ms. Set the pulse length.
6. Press once to get to the next menu. The display will show the setting for
pulse output 1. Depending on the meter type, the available choices are:
4 configurable I/Os
No output
Out 1
Out 2
Out 3
Out 4
If choosing an I/O that is not pulse output configured, the option is set to "no
7. The first pulse output is now fully configured. Depending on the meter
type, up to four pulse outputs can be set. If your meter supports multiple
pulse outputs, use
set them the same way as pulse output 1.
1. Choose the Settings icon in the main menu, press
2. Choose "I/O", press
3. The display will now show I/O 1. To change I/O, use
I/ O, press the button. Depending on the meter type, different choices
can be made for the I/O, see table 4:2.
2
4 static I/Os
No output
Out 1
Out 2
-
-
button.
to toggle down to the remaining pulse outputs and
.
Available choices
• Input
• Alarm out
• Communication out (Comm.out on display)
• Pulse out (Pul.out on display)
1
• Tariff out
• Always on
• Always off
• Alarm out
• Communication out (Comm.out on display)
• Pulse out (Pul.out on display)
3
• Tariff out
• Always on
• Always off
35
1 static I/O
No output
Out 1
-
-
-
.
or . To set an
A43/A44
User Manual