Setting Previous Values; Setting Load Profile - ABB A43 User Manual

Meter Settings
Step
3
4
5

4.1.15 Setting Previous Values

To set set the previous values, perform the following steps:

4.1.16 Setting Load Profile

To set the load profile, perform the following steps:
Page
1/8
2/8
3/8
4/8
5/8
6/8
2CMC48001M0201
Revision: C
Input
Press and choose
Input.
Use to toggle to the first Press
configuration. Four configu- page.
rations are available. Set
the tariff that shall be active
for each configuration.
-
1. Choose the Settings icon in the main menu, press
2. Choose "Previous Values" (Prev.Val. on the display), press
3. Perform the setting. The options are day, week and month.
4. If setting week, use
5. Set what week-day the snapshot of the values will be taken.
1. Choose the Settings icon in the main menu, press
2. Choose "Load Profiles" (Load Pro on the display), press
3. The first page will show the interval for the quantity active energy
imported (Act.Imp.Tot on the display). Up to eight channels (pages) are
available to configure, see table below.
Quantity
Active Energy Imported total
Active Energy Exported Total
Reactive Energy Imported Total
Reactive Energy Exported Total
Input Counter 1
Input Counter 2
Clock
Press and choose Clock. Press
If the display says
"Config found
No reset"
then reset the configuration
by pressing and
choosing
"Reset"
to get to the next
Set the desired tariffs with
start-time and if the tariff is to
be used or not. Up to eight
tariff switch times can be set,
four for weekdays and four
for weekends. Set at least
one tariff for weekdays
(Mon-Fri) and one for week-
ends (Sat-Sun) even if the
values are the same.
to go to the next step.
On display
Act.Imp.Tot
Act.Exp.Tot
React.Imp.Tot
React.Exp.Tot
Inp.Ctr 1
Inp.Ctr 2
43
Communication
and
choose Comm.
The tariff source is
now set for commu-
nication.
-
.
.
.
.
Predefined
value
1 hours
1 hours
1 hours
1 hours
1 hours
1 hours
A43/A44
User Manual