Starter Solenoid Bench Test; Starter Solenoid Operation - Polaris 2014 Sportsman 570 EF Service Manual

Table of Contents

specification.

Starter Mounting Bolts and Nut:

7 ft. lbs. (10 Nm)

8. Connect the (-) negative battery cable, install the

seat, and left side panel.

Starter Solenoid Bench Test

Test the start solenoid by powering the solenoid using

battery voltage for a maximum of 5 seconds. With the

solenoid energized, resistance should read about 0 - 0.5

Ohms between terminals (A) and (B). If resistance

measurement is out of specification, replace the starter

To energize the Starter Solenoid the following must

• The brake must be applied to provide a ground

path via the Orange wire.

• The key switch must be turned to the "start"

position to provide 12V power via the Green /

9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual

• Once the pull-in coil is energized, the solenoid

provides a current path for 12V power to reach the

starter motor.

Table of Contents