Polaris 2014 Sportsman 570 EF Service Manual page 305

3. Install and torque both lower control arm bolts.
Lower Control Arm Bolt:
37 ft-lbs (50 Nm)
4. Lift bearing carrier until top aligns with upper control
arm. Install and torque upper control arm bolt and
torque to specification.
Upper Control Arm Bolt:
37 ft-lbs (50 Nm)
5. Pull drive shaft outward and install hub onto
driveshaft splines. Apply anti-seize to the splines.
6. Install cone washers with domed side facing
outward.
7. Install retainer nut, wheel and wheel nuts.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
8. Remove jack stand and torque axle nut and wheel
nuts to specification.
9. Install a new cotter pin. Tighten nut slightly to align
holes if required.
© Copyright 2013 Polaris Sales Inc.
FINAL DRIVE
Wheel Nut:
Steel Wheels:
27 ft-lbs (37 Nm)
Aluminum Wheels:
30 ft-lbs + 1/4 turn
(41 Nm + 1/4 turn)
Rear Hub Nut:
80 ft-lbs (109 Nm)
7
7.23