Polaris 2014 Sportsman 570 EF Service Manual page 81

6. Remove the pressure cap from the filler neck.
7. Completely drain cooling system and engine as
outlined in this chapter.
8. Disconnect the stator wire connector and unsecure
the wiring from the front engine mount bracket.
9. Remove the CPS sensor from the stator cover on the
right-hand side of the engine. Inspect CPS O-ring
and replace if needed.
10. Remove the oil dipstick.
11. Remove the bolts (1) retaining the water pump cover
to the stator cover.
12. Remove the water pump cover (2) and water pump
cover gasket (3). Discard the water pump gasket (3).
13. Remove the water pump impeller (4).
NOTE: The water pump impeller (4) uses reverse
(LH) threads.
14. Remove the bolts (5) securing the stator cover (6) to
the engine.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
15. If needed, install the stator cover removal handle tool
(PA-49317) to the water pump cover bolt holes to aid
in stator cover removal.
NOTE: Image For Reference Only.
The flywheel contains powerful magnets. Use caution
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
16. Remove and discard the stator cover gasket.
Be sure engine coolant does not contaminate the
17. Bring the stator cover assembly to a clean work
bench.
© Copyright 2013 Polaris Sales Inc.
CAUTION
when removing the stator cover.
result.
CAUTION
engine oil during stator cover service.
ENGINE
3
3.23