Gear Selector Removal; Transmission Removal; Transmission Installation - Polaris 2014 Sportsman 570 EF Service Manual

TRANSMISSION

Gear Selector Removal

1. Push linkage rod out of bushing clip to remove.
2. Remove screws attaching gear selector mount to
frame.
3. Remove gear selector handle by prying the cover off
and removing the retaining screw.

Transmission Removal

1. Place vehicle in "park". Raise and securely support
rear of ATV under the frame. Remove both rear
wheels.
2. Disconnect the BLACK (negative) battery cable from
the battery.
3. Remove:
• Seat
• Side Panels
• Rear Rack/Rack Support
• Rear Cab Assembly
• Left/Right Foot Wells
4. Disconnect the vehicle speed sensor and gear
selection switch connectors from the transmission.
5. Disconnect transmission vent hose from the nozzle.
6. Disconnect shift rod end from transmission bellcrank.
7. Remove PVT outer cover, drive and driven clutches,
and the inner PVT cover. (refer to Clutch Removal in
Chapter 6).
8. Remove fasteners securing upper control arms to
stabilizer brackets and transmission brackets.
9. Remove the stabilizer bar links from the upper
control arms. Remove lower shock-to-control arm
fasteners.
10. Remove both rear drive shafts from transmission.
11. Remove the fasteners securing the stabilizer
assembly to the upper frame.
12. Remove the two mounting bolts that secure the front
of the transmission to the frame.
13. Remove all lower transmission mounting fasteners
from each side.
14. Remove the upper transmission support bracket
completely from the ATV.
15. With the help of an assistant, lift and remove
transmission out of rear of frame while pulling the
output shaft from the propshaft yoke.

Transmission Installation

1. Apply Polaris Premium All Season Grease (PN
2871423) to splines of front output shaft ,install new
O–ring in prop shaft.
8.8
2. With the help of an assistant, install transmission into
3. Loosely install the bottom and front transmission-to-
4. Loosely install the upper transmission mount bracket
5. Reinstall the stabilizer bar assembly. Loosely install
6. Apply anti-seize to splines of rear drive shafts and
7. Install the stabilizer bar links and shocks into the
8. Install PVT system. Refer to Chapter 6 PVT section
9. Install transmission vent line. Be sure vent line is not
10. Reconnect the speed sensor and gear selection
11. Reconnect the shift rod.
12. Reinstall:
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
place from the rear of the frame, ensuring that the
output shaft and propshaft align and slide together.
frame screws and through-bolts.
to the transmission and upper frame rail.
the screws that secure the assembly to the frame,
and then the bolts/screws that attach the brackets to
the transmission.
insert drive shafts into transmission. Install the upper
control arms into the
assembly brackets to retain the rear suspension.
upper control arms.
for procedures and torque specifications.
kinked or pinched.
switch connectors to the transmission.
• Seat
• Side Panels
• Rear Rack/Rack Support
• Rear Cab Assembly
• Left/Right Foot Wells
transmission/stabilizer