Engine Installation - Polaris 2014 Sportsman 570 EF Service Manual

ENGINE

Engine Installation

Use the following procedure to reinstall the engine
assembly.
1. Attach engine with suitable lifting straps to an
overhead or portable engine hoist.
2. Remove the engine stand adapter plate.
3. Use the overhead or portable engine hoist and
suitable engine straps to lower the engine onto the
left footwell support.
NOTE: Have an assistant help guide the engine
in and out of the vehicle while using an engine
hoist to prevent personal injury or damage to
vehicle components.
4. Remove the lifting straps and overhead or portable
engine hoist and remove the support previously
installed under the transmission case during the
engine removal process.
5. Have an assistant help lift and rotate the engine into
the frame.
6. Install the rear engine mount fasteners .
IMPORTANT: Do not tighten fasteners at this
time.
7. Install the front engine mounts and fasteners.
IMPORTANT: Do not tighten fasteners at this
time.
8. Torque the rear
specification.
Flanged nut:
23 ft-lbs ± 10% (50 Nm ± 10%)
3.34
engine mount fasteners
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
9. Install the Clutch Center Distance Tool (PN 2871710)
onto the crankshaft and transmission input shaft to
properly position the clutch center distance. (See
CLUTCH ALIGNMENT, page 6.13)
NOTE: Verify clutch center to center alignment
at this time.
If necessary shim the rear engine to frame mount
as required.
10. Torque the fasteners that attach the front engine
mounts to the engine to specification.
to
Front engine mount:
37 ft-lbs ± 10% (50 Nm ± 10%)