Polaris 2014 Sportsman 570 EF Service Manual page 277

12. Press down on the top of the spider assembly,
pushing the spider onto the shaft.
13. Slowly compress the spider into place. If the spider
appears to bind while compressing, stop and make
sure the skip-tooth on the shaft and the spider are
aligned. Once the spider passes the retaining ring
notch on the shaft, install the retaining ring.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
14. Install the cam (helix) assembly over the shaft. Line
up the "X" on the cam, "X" on spider, and "X" on the
stationary sheave or use the marks previously made
before disassembly. NOTE: If the cam assembly
(helix) is difficult to install, be sure the sheaves are
aligned. To align the sheaves place the clutch
assembly on a flat surface with the cam assembly
(helix) side down. Press down on the moveable
sheave belt face with both hands and the helix will
release.
15. Use a T25 Torx driver to install the four helix
retaining screws and torque to specification.
© Copyright 2013 Polaris Sales Inc.
CLUTCHING
Helix Retaining Screws:
42-52 in. lbs. (4.75 - 5.88 Nm)
6
6.43