Tire Inspection; Cv Shaft Boot Inspection; Frame, Nuts, Bolts, Fasteners - Polaris 2014 Sportsman 570 EF Service Manual

4. Securely tighten the wheel nuts to the proper torque
listed in the table.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered rear
wheel nuts, make sure tapered end of nut goes into
taper on wheel.

Tire Inspection

• Improper tire inflation
maneuverability.
• When replacing a tire always use original
equipment size and type.
• The use of non-standard size or type tires may
affect ATV handling.
Tire Tread Depth
Always replace tires when tread depth is worn to 1/8" (3
mm) or less.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
Operating an ATV with worn tires will increase the
possibility of the vehicle skidding easily with possible
Always replace tires when the tread depth measures 1/

CV Shaft Boot Inspection

Inspect the CV shaft boots in the front and rear of the
ATV for damage, tears, wear, or leaking grease. If the
rubber boot exhibits any of these symptoms, replace the
boot. Refer to Chapter 7 for CV boot replacement.
may affect ATV

Frame, Nuts, Bolts, Fasteners

Periodically inspect the torque of all fasteners in
accordance with the maintenance schedule. Check that
all cotter pins are in place. Refer to specific fastener
torques listed in each chapter.
© Copyright 2013 Polaris Sales Inc.
MAINTENANCE
WARNING
loss of control.
Worn tires can cause an accident.
8" (.3 cm) or less.
2
2.29