Table of Contents
Advertisement
2. To replace either of the bulbs, turn the holder
assembly counter-clockwise to remove and pull out.
Turn the holder assembly clockwise to install. Refer
to the parts manual for the correct bulb part number.
Brake Light Switch
1. Disconnect battery.
2. Remove the front rack.
3. Remove the front cover.
The brake pressure switch is located below the ecu.
THe vehicle wiring harness will need to be pushed to
the side to gain access.
4. Disconnect wire harness from switch.
5. Connect an ohmmeter across switch contacts.
Reading should be infinite (OL).
6. Apply brake at handlebar lever and check for
continuity between switch contacts. Replace switch if
there is no continuity or greater than .5 ohms
resistance when the brake is applied with slight
pressure.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
ELECTRICAL
10
10.39
Advertisement
Chapters
Table of Contents
Troubleshooting
