Polaris 2014 Sportsman 570 EF Service Manual page 58

Table of Contents

3. Place a chalk mark on the center line of the front tires

approximately 10" (25.4 cm) from the floor or as

close to the hub/axle center line as possible. NOTE:

It is important that the height of both marks be

equally positioned in order to get an accurate

measurement.

4. Measure the distance between the marks and record

the measurement. Call this measurement "A".

5. Rotate the tires 180

backward. Position chalk marks facing rearward,

even with the hub/axle centerline.

6. Again measure the distance between the marks and

measurement "B" from measurement "A". The

difference between measurements "A" and "B" is the

vehicle toe alignment. The recommended vehicle toe

tolerance is 1/8" to 1/4" (.3 to.6 cm) toe out. This

means the measurement at the front of the tire (A) is

1/8" to 1/4" (.3 to .6 cm) wider than the measurement

at the rear (B)

Wheel Toe-Out:

(A) - (B) = 1/8" to 1/4" (3 to 6 mm)

by moving vehicle forward or

9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual

Chapters

Table of Contents