ENGINE
15. Install and torque the stator cover fasteners in
sequence to specification.
Stator Cover and Water Pump Cover:
9 ft-lbs (12 Nm)
3.28
16. Measure the installed height of the new mechanical
17. Install the water pump impeller (4).
18. Install a new water pump cover gasket.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
seal as shown below. If not within specification,
remove and discard the mechanical seal and properly
install new mechanical seal as outlined in this
chapter.
Mechanical Water Pump Seal Installed Height:
0.280" - 0.287" (7.2 +/- 0.1 mm)
NOTE: The water pump impeller (4) uses reverse
(LH) threads. Finger tighten only.