Polaris 2014 Sportsman 570 EF Service Manual page 176

FUEL SYSTEM - GENERAL
3. Disconnect the vehicle harness from the TPS.
4. Remove the (2) Phillips-head mounting screws and
replace the TPS. Reconnect the vehicle harness to
the TPS.
NOTE: If replacing the TPS or throttle body, you
must set the TPS voltage to specification.
TPS Adjustment Using Digital Wrench :
5. Assemble SmartLink Module and connect the
diagnostic interface cable to the vehicle to allow
Digital Wrench use (see "Digital Wrench - Diagnostic
Connector").
6. Select the appropriate vehicle and open the data
display grid. Click on the meter icon next to "TPS
Volts".
4.30
7. Loosen the TPS mounting screws.
8. Rotate the TPS until your display reading is within
9. Retighten the TPS mounting screws and torque to
10. Verify voltage reading did not change. If voltage
11. Reinstall items that were removed to access TPS
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
specification.
TPS Output Reading (Digital Wrench ):
0.46 ± 0.03 Vdc
specification.
TPS Mounting Screws:
17.7 in-lbs (2 Nm)
reading is now out of specification, repeat steps 3 -
5.
sensor.