Example: Starting 2Pulse - Siemens SIMATIC ET 200S Operating Instructions Manual

5.2

Example: Starting 2PULSE

Task
These instructions guide you to a functioning application that will enable you to become
familiar with and check the basic hardware and software functions of your 2PULSE. The
"Pulse Output" mode will be used as an example here. Channel 0 of the 2PULSE is used in
this example.
Requirements
The following requirements must be satisfied:
• You have commissioned an ET 200S station on an S7 station with a master.
• You must have the following:
Installation and Fitting
1. Install and wire the TM-E15S24-01 terminal module (see figure below).
2. Connect the 2PULSE to the terminal module (you will find detailed instructions in the
Figure 5-1
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
– A TM-E15S24-01 terminal module and
– a 2PULSE.
ET 200S Distributed I/O System
example.
Terminal Assignment of the 2PULSE for the Example
Manual). It is not necessary to wire the 2PULSE for this
2PULSE
5.2 Example: Starting 2PULSE
255