Special Features In Active Profibus; Tion; General; Display - ProMinent PROFIBUS DP DULCOMETER diaLog DACb Supplementary Instructions Manual

1.3 Special features in active PROFIBUS

1.3.1 General

1.3.2 Display

Supplementary instructions PROFIBUS
3. Use the cursor keys to select the menu item
Configuration ' and confirm with the [OK] key
'Configuration' menu appears.
ð The
'Configuration' menu, you can:
4. In the
'Remote configuration'
n
– Activating/deactivating remote configuration.
'Address'
n
– Here you can set the address at which the controller
in the bus can be accessed.
'Termination'
n
– Here you can set whether the controller is the last
device in the bus and whether or not the terminating
resistance is activated.
® DP operation
Setting and programming
In PROFIBUS
be manually set or programmed. To set or pro‐
gramme the controller, set the PROFIBUS
'inactive' .
When PROFIBUS DP operation is selected, the settings from
®
n
the last operating mode without PROFIBUS
By contrast, the settings made via the PROFIBUS
saved. These only apply as long as the controller is linked to
the PROFIBUS DP.
®
If the controller is set to PROFIBUS
n
The controller can be controlled again by pressing the
[Stop/Start] key. The start command is given via the PRO‐
FIBUS DP module.
®
In running PROFIBUS ® DP operation there are further identifiers in
the operating indicator.
Common identifiers
The common identifiers are described in the con‐
troller operating instructions.
® DP operation, the controller cannot
® DP are applied.
DP operation, it stops.
®
® DP
'Bus
® DP to
® DP are not
5