Configuration In The Remote Controller Operating Mode - Festo CPX-FB6 Manual

2. Commissioning

2.1.9 Configuration in the remote controller operating mode

Configuration of the bus
node remote controller
operating mode
2-42
If there is a CPX-FEC or CPX-CEC in your CPX terminal, you can
operate the bus node in the remote controller operating
mode. The bus node then occupies 8 input bytes and 8 out-
put bytes. These are available to the control program in the
CPX-FEC or CPX-CEC.
1. Ensure that DIL switch
mote controller position (see section 1.2, Tab. 1/1).
2. Set 8 I/O bytes with DIL switch
Tab. 1/7).
The bus node is thus configured as remote controller.
1
of the bus node is in the re-
4
( see section 1.2,
Festo P.BE-CPX-FB6-EN en 1207c