Connecting The Fieldbus - Festo CPX-FB6 Manual

1. Installation

1.3.3 Connecting the fieldbus

1-18
Note
Observe that only the plugs from Festo guarantee compli-
ance with protection class IP 65/IP 67.
If the continued bus interface is not connected:
Seal the continued bus interface with the supplied cover.
•
Connecting with sub-D plugs of other manufacturers:
Replace the two flat screws with bolts (type
•
UNC4-40/M3x8).
Connect the cable screening to the plug housing.
•
Connecting with the fieldbus plugs from Festo
Observe the assembly instructions for the fieldbus plugs.
•
You can conveniently connect the CPX terminal to the fieldbus
with the fieldbus plugs from Festo.
Connection
Incoming bus interface
Continued bus interface
Fig. 1/5 shows the connection with the fieldbus plugs from
Festo.
Fieldbus plug type
FBS-SUB-9-BU-IB-B
FBS-SUB-9-GS-IB-B
Festo P.BE-CPX-FB6-EN en 1207c