Festo CPX-FB6 Manual page 12

Contents and general safety instructions
X
Note
This description refers to the following revision:
Revisions
as from software status 26 May
1)
2003
2)
from Revision 22
1)
Software status (SW) see name plate
2)
Revision identification, see name plate
Fig. 0/1: New CPX-FB6 modules supported through the bus
node
This description contains specific information on installing,
commissioning, programming and diagnosing with the CPX
bus node for Interbus.
Additional information about Interbus can be obtained in the
internet:
– www.interbusclub.com
– www.ibsclub.com
General basic information about the mode of operation,
mounting, installation and commissioning of CPX terminals
can be found in the CPX system description.
Newly supported modules
– Support for the handheld,
type CPX-MMI-1
– MPA1 pneumatics (type 32)
– MPA1 pneumatics (type 33
and 34)
– MPA2 pneumatics (type 32,
33 and 34)
– CPX-FB6 as remote controller
(e.g. with CPX-FEC)
– CPX-CP interface
– Pneumatic interface for
VTSA- and /VTSA-F-Pneu-
matic (Type 44 and 45)
Festo P.BE-CPX-FB6-EN en 1207c