Festo CPX-FB6 Manual page 26

1. Installation
1-10
Setting the peripheral fault mode
You set the error mode with switch element 1 of the dual DIL
switch 2:
Peripheral fault mode
Report all errors
Filter error messages
Errors during the monitoring of
the load voltage supply will be
ignored
Tab. 1/3: Setting the peripheral fault mode
With the setting "Filter error messages", any voltage errors
which occur will not be reported to the interface module as
peripheral faults (see also section 3.3.4). In this way, you can,
for example, suppress unnecessary error messages during
the commissioning phase.
The setting of the DIL switch has precedence over the para-
metrisation of defined settings.
2
Setting DIL switch 2.1
2.1: OFF
(default)
2.1: ON
Festo P.BE-CPX-FB6-EN en 1207c