Cleaning The Printer - SINTERIT Lisa Pro User Manual

IMPORTANT!
E. Cleaning the printer
The system will guide you through printer cleaning process when you will proceed straight
after printing. You can also do it later using CLEAN PRINTER option displayed in main menu.
All actions should be confirmed by pressing the DONE button.
1. Remove the powder from the OVERFLOW BIN.
2. Transfer it to the container in which you will mix the powder from the printer, with the
FRESH POWDER later (to refresh the used powder and prepare it for the next print).
3. Remove and clean the LASER PROTECTIVE GLASS. It is recommended to clean the
glass before and after each print:
a. in order to clean the glass, follow the instructions in the chapter "Maintenance
and service of the Sinterit LISA PRO Printer"
b. Place the glass back then confirm all actions by pressing the DONE button.
Image 42. OVERFLOW BIN cleaning screen.Step 1.
STOP!
33
● Always pay attention to the messages displayed on the main display
of the Sinterit LISA PRO printer. The Sinterit STUDIO 2019 software
calculates the amount of FRESH POWDER, which needs to be
added to that already inside of the printer. Not acting according to the
messages may result in the following print being incorrect.
● Even if you do not intend to make the following print right after the
first one, mix both powders in the proportions given by the Sinterit
STUDIO 2019 software. Store in the container for the PRINT READY
POWDER.
● Watch out for the elements of the heating system of the machine.
● Do not clean the glass under running water.
● The cleaning process should be carried out outside of the machine.
Image 43. OVERFLOW BIN cleaning screen . Step 2.
​
Sinterit Lisa PRO USER MANUAL