Finishing The Print - SINTERIT Lisa Pro User Manual

B. Make sure that the nitrogen pressure is between 4 and 8 [bar] during the whole
process. Remember that it may change if you're using a bottle and a pressure
regulator.
C. Start the printing process as usual (Chapter 9). If the .scode file is properly prepared,
the printer will automatically control the use of the nitrogen chamber.
D. Finishing the print
When the process
information of possibility to remove printout will
be displayed.
● By clicking REMOVE PRINT the PRINT
BED will raise, enabling the printout to
be taken out from the chamber.
● By clicking BACK the system will return to
the first screen.
1. When the printing is complete and the print
has cooled down message YOU CAN NOW
REMOVE THE PRINT FROM PRINTER will
appear on the screen. Click DONE to
complete the printing process and open the
printer.
30
Image 35. Nitrogen input.
will be finished, the
​
Sinterit Lisa PRO USER
Image 36. Printing finished screen.
Image 37. Printing finished screen.
MANUAL