Cleaning The Printer - SINTERIT LISA X Manual

Fig. 3.3 Moving the IO BOX to the foldable tray
10. Clean the printout from unsintered powder. You may use the brushes and the probe provided in Dedicated Powder
Tools.

4. Cleaning the printer

IMPORTANT!
The SLS powders are hygroscopic (draw moisture out from the air). The print chamber and the
overflow container are not 100% airtight. Leaving the powder inside of the printer may cause it to
become wet and lose its intended properties.
1. Press YES, I DO, to start cleaning the printer.
2. Make sure no miscellaneous items remain in the print chamber. Afterwards press AUTO HOME to begin homing the
Feed Bed and Print Bed positions.
3. Collect the remaining powder in the print chamber with the PHS or ATEX Vacuum Cleaner hose. Afterwards press
DONE.
DANGER!
The vacuum cleaner used to collect the powder must be suitable for handling combustible dust.
Sinterit recommends the ATEX Vacuum Cleaner available in the offer.
4. Press the arrow buttons to the left and right to move the recoater and collect the remaining powder underneath.
5. Once the print chamber is clean, choose DONE.
6. Press OPEN AND UNLOCK, to unlock the overflow container.
IMPORTANT!
After 10 seconds the lock will re-engage and it will no longer be possible to open the overflow door.
If you still want to slide the overflow bin out, press the UNLOCK OVERFLOW button again back on
the LCD screen.
7. Open the overflow door and slide out the drawers. (fig. 4.1).
1
or
1
or to the PHS worktop
2
2
to clean the printout.
Sinterit LISA PRO User Manual | 9