SINTERIT Lisa Pro User Manual page 32

IMPORTANT!
The blockade of the device is engaged up until the internal temperature will not
drop below 50 [⁰C].
There is no possibility to open the lid before the temperature drops.
Remember that the print inside the printer may still be hot, despite the fact that
the printer has cooled down!
2. In order to open the printer, unlock the magnetic lock on the lid.The lock releases the
blockade for 10 seconds. After 10 seconds the lock will become active again.
3. Softly press the lid and then lift it by pulling up.
Image 38. A correct condition of the powder after printing (visible cracks on the surfaces of both BEDs).
4. Using the provided 2 parts kit of plates, carefully transfer the entire content of the PRINT
BED to the plate for carrying the prints, and transfer it to the mold included in the set.
Leave the cuboid with the print to cool down, for at least one hour (see images 39).
31
IMPORTANT!
Put on the safety clothing included in the set (mask,
glasses, gloves).
.
​
Sinterit Lisa PRO USER MANUAL