Next Steps Required To Use The Printer For The First Time - SINTERIT Lisa Pro User Manual

8. Mount the glass: slide the metal tabs of the LASER PROTECTIVE GLASS module
into the holders located in the middle of the lid. Press gasket gently. After obtaining
the perfect fit, screw the knurled nuts on to the visible screws.
Image 16. Correct placement of the LASER PROTECTIVE GLASS on the heating module.
9. Join the heating module with the lid - using the metal split pin.
10. Clean the glass one more time from any finger marks or stains if present.
B. Next steps required to use the printer for the first time
1. Check (wearing gloves or through paper – see image above) whether the heaters
are stable in their sockets. If there is any dust/powder on them, blow it gently off
with air.
22
Image 17. Correct closing of the heating module.
​
Sinterit Lisa PRO USER MANUAL