Preparing The Machine To Print For The First Time; Install The Laser Protective Glass - SINTERIT Lisa Pro User Manual

8. Preparing the machine to print for the first
time
A. Install the LASER PROTECTIVE GLASS
CAUTION!
Beware of ​ s harp edges. ​ P ut on the safety gloves in order to protect yourself
from injuring the hand against the edge of the heating module.
1. Turn of the safety key switch and turn off the power switch.
2. While holding the heater module, take out the split pin positioned on the top of the
inner part of the lid.
3. Lower the heating module to get access to the place dedicated for the LASER
PROTECTIVE GLASS.
4. Unscrew two knurled nuts from the LASER PROTECTIVE GLASS module.
5. Remove the module from the locking holders located in the middle of the lid.
Image 12. Heater module - split pin​ system.
6. Take out the LASER PROTECTIVE GLASS out of the box (from the additional
equipment package).
7. Rub the surface of glass carefully with a cotton cloth soaked with 2% salicylic acid
(ethanol solution) or any other ethanol-based solution. ​ D o not use isopropyl
alcohol​ ! Pay attention to any fibers left on the surface. Clean both sides.
Image 14. Repackaging of LASER PROTECTIVE GLASS.
21
Image 15. Cleaning of LASER PROTECTIVE GLASS.
​
Sinterit Lisa PRO USER
Image 13. Heater module - ​ o pening.
MANUAL