SINTERIT Lisa Pro User Manual page 35

4. A message FEED BED MIGHT NOT HAVE
BEEN CLEANED AFTER LAST PRINT will
appear.
5. Cleaning the FEED BED should be
confirmed by pressing CLEAN FEED BED
button. The FEED BED will be raised and
the PRINT BED will be lowered.
6. All remaining powder from FEED BED
should
Precisely clean the FEED BED from the
remaining unsintered powder including the
BEDs surroundings. This can be done with
the use of a spatula.
SKIP button can be pressed if cleaning
process had been previously done.
7. Ensure that the movement path of the
RECOATER
remove all objects from the printer
chamber.
8. Check if all elements are at their default
positions (RECOATER, LASER). Check
the tension
RECOATER's BELT. Confirm by clicking
DONE button.
STOP!
For cleaning the guide bar of the RECOATER , it is recommended to use a
paintbrush with a soft bristle (included in the set), or compressed air (when
there is no powder inside the printer). After cleaning, the guide bar of the
RECOATER should be lubricated with silicone oil (included in the accessory
kit).
34
be placed into PRINT BED.
is not obstructed
and condition
Image 44. Clean FEED BED screen.
Image 45. Removing the powder from the FEED
and
of the
Image 46. Clean PRINT BED screen 1.
​
Sinterit Lisa PRO USER
BED.
MANUAL