Power Supply - SINTERIT Lisa Pro User Manual

B. Power supply:
● Use only the power cord supplied with the product.
● The printer must be connected to a grounded outlet to prevent electric shock in the
event of a fault.
● When connecting/disconnecting the plug to/from the power source always hold the
cover, not the cord.
WARNING!
Do not use cables from other devices. Using the power cables from other
devices or connecting the power cord supplied with the product to other
devices may cause fire or electric shock.
ATTENTION!
Never disassemble, modify or repair the power cord, plug, devices inside the
printer, except as described in the product manual.
● The product should be placed near a wall outlet, which can be easily unplugged.
● It is recommended to use UPS units that, in the case of a momentary power failure,
will allow the printing process to finalise.
● When an extension cord is used for the power supply of the product, make sure that
the total power consumption of all devices connected to it does not exceed the
extension cord's limit. Also, make sure that the total current drawn by connected
equipment does not exceed the ampere rating for AC wall outlet.
● Power cables should be placed in such a place that they are not rubbed, cut, pulled or
twisted.
ATTENTION!
Do not place objects on the power wires.
Do not place power cords in path where people will have to walk or run.
Pay special attention to the fact that the power cables are not bent at the
points of connection of the printer.
Disconnect the plug whenever it is planned to shift/transfer the machine.
In the following situations, unplug the product from the power supply and contact a qualified
service personnel:
1. the power cord or plug is damaged,
2. some liquid got into the product,
3. the product has been dropped or the case has been damaged;
4. the product does not operate properly or clear changes in efficiency have been
observed.
Do not adjust controls that are not described in the manual.
16
​
Sinterit Lisa PRO USER MANUAL