Installation Of Printer; Environment And Place Of Installation - SINTERIT Lisa Pro User Manual

4. Installation of printer

To ensure safe use of the Sinterit LISA PRO Printer, please read and follow the instructions
below. Keep this manual for future use. Also, be sure to follow all warnings and instructions
marked on the product.
WARNING!
Only trained and qualified personnel should install, replace or service the
equipment.
The device should be installed in accordance with these instructions and by
trained personnel.
The device can be transported only in its original package in the way that prevents it from
moving inside. It should be also thoroughly protected against any environmental factors that
could affect it.
The device should be stored indoors in original packages in spaces without chemical fumes or
reactive substances, at temperature between 0⁰C÷40⁰C and relative humidity not higher than
80%.
A. Environment and place of installation
● The Sinterit LISA PRO Printer should be placed at room temperature.
● The room must be well ventilated, adequately to its size.
● The product should be placed on a flat, stable surface that extends beyond all edges
of the product. If you place the product by the wall, the distance between the product
and the wall should be greater than 500 [mm] (20 [in]).
● The product will not work properly if it is set at an angle.
● The device should be used in a room at around 22⁰C and should not be placed near
air conditioners' vents.
ATTENTION!
Do not place or store the product:
ATTENTION!
15
● outdoors;
● in areas with large amounts of dust;
● in places subject to shocks, vibrations, high temperature and/or
humidity, and extreme changes in temperature and humidity;
● near water, or heat sources;
● near inflammable and volatile substances, concentrated acids or
corrosive vapours;
● in places easily accessible to children and animals.
● Never use wood, equipment with wooden elements and flammable
substances while working with the printer.
● The min. distance between the printer and wooden parts is 500 [mm].
● The printer emits large amounts of heat (80​
prohibited to place it on the wood or wooden furniture.
​
Sinterit Lisa PRO USER MANUAL
o​
C), and therefore it is