Cleaning The Prints - SINTERIT Lisa Pro User Manual

10. Cleaning the prints
1. By using a brush with a nylon bristle, initially clean the print of any unsintered powder,
until an outline of the print is visible. If the mass is still warm, leave it to cool down.
2. Separate the prints from the mass and continue to clean them with the nylon brush
included in the set. Mash up the clumps of powder remaining in the form (this will help
to sift the remaining powder through the sieve).
3. After
SANDBLASTER
Sinterit online store) may be used
to clean the print details.
4. Combine the unsintered powder
from the PRINT BED with the
powder remaining in the FEED
BED and OVERFLOW BIN. Sift the
entire unsintered powder through a
sieve (included in the set) or use
Sinterit POWDER SIEVE available
at Sinterit online store.
37
an initial cleaning,
(available
Image 52. Cleaning the prints.
a
at
Image 53. Sinterit SANDBLASTER.
Image 54. Sieving the powder using Sinterit POWDER SIEVE.
​
Sinterit Lisa PRO USER MANUAL