Examples Of Using Issu Commands For Issu On An Eirf System; Feature Upgrade To A Compatible Version - HP 10500 Series Configuration Manual

flash:/soft-version2.bin
Main startup software images:
flash:/cmw710-boot-test.bin
flash:/cmw710-system-test.bin
flash:/soft-version2.bin
Backup startup software images:
None
# Verify that the IRF fabric is running the new feature version.
<Sysname> display version
HP Comware Software, Version 7.1.045, Release 7169P01
Copyright (c) 2004-2015 Hewlett-Packard Development Company, L.P.
HP uptime is 0 weeks, 0 days, 2 hours, 18 minutes
Last reboot reason : Cold reboot
Boot image: flash:/10500-CMW710-BOOT-R7169P01.bin
Boot image version: 7.1.045, Release 7169P01
Compiled Aug 14 2015 11:56:35
System image: flash:/10500-CMW710-SYSTEM-R7169P01.bin
System image version: 7.1.045, Release 7169P01
Compiled Aug 14 2015 11:56:35
Examples of using issu commands for ISSU on an
eIRF system

Feature upgrade to a compatible version

Upgrade requirements
As shown in
is connected only to the master. PEX 2 is connected to both parent devices.
In the parent fabric:
• The master has two MPUs (active in slot 0 and standby in slot 1) and two LPUs (in slot 8 and slot 12).
The subordinate member has one MPU (in slot 0) and one LPU (in slot 8).
•
Upgrade the feature as follows:
From a0041 to the compatible version a0042 on the parent IRF fabric.
•
From d2402 to the compatible version d2403 on the PEXs.
•
Figure 41, the eIRF system contains a two-chassis parent fabric and two 5700 PEXs. PEX 1
176