Configuration Procedure; Verifying The Configuration; Non-Issu Software Upgrade Example (For Irf Mode); Network Requirements - HP 10500 Series Configuration Manual

Hide thumbs Also See for 10500 Series:
Table of Contents

Advertisement

Configuration procedure

# Configure IP addresses and routes. Make sure the device and the TFTP server can reach each other.
(Details not shown.)
# Complete TFTP settings on both the device and the TFTP server. (Details not shown.)
# Display information about the current software images.
<Sysname> display version
# Use TFTP to download the image file startup-a2105.ipe from the TFTP server to the root directory of the
flash on the active MPU.
<Sysname> tftp 2.2.2.2 get startup-a2105.ipe
# Back up the image file to startup-a2105-backup.ipe. Skip this step if the flash does not have sufficient
space.
<Sysname> copy startup-a2105.ipe startup-a2105_backup.ipe
# Specify startup-a2105.ipe as the main startup image file for both MPUs.
<Sysname> boot-loader file flash:/startup-a2105.ipe slot 0 main
<Sysname> boot-loader file flash:/startup-a2105.ipe slot 1 main
# Specify startup-a2105-backup.ipe as the backup startup image file for both MPUs.
<Sysname> boot-loader file flash:/startup-a2105-backup.ipe slot 0 backup
<Sysname> boot-loader file flash:/startup-a2105-backup.ipe slot 1 backup
# Verify the startup image settings.
<Sysname> display boot-loader
# Reboot the device to complete the upgrade.
<Sysname> reboot

Verifying the configuration

# Verify that the device is running the correct software.
<Sysname> display version
Non-ISSU software upgrade example (for IRF
mode)

Network requirements

As shown in
Each IRF member device has two MPUs: one in slot 0 and one in slot 1. The global active MPU is in slot
0 on the master device.
Figure
34, use the file startup-a2105.ipe to upgrade software images for the IRF fabric.
129

Advertisement

Table of Contents
loading

Table of Contents