Running The Comware Software; Upgrading Comware Software Through The Console Port - HP 10500 Series Configuration Manual

NOTE:
Basic Comware V7 software images include a .bin boot image and a .bin system image. A system must
•
have the two images to operate appropriately. They are released both in separate .bin files and in
an .ipe package file so you can update the images separately or as a whole. You can set one Comware
software image as a main (M) or backup (B) image. For more information, see
attribute of a Comware software
At startup, the device always attempts to boot first with the main Comware software images. If the
•
attempt fails, for example, because the image file is corrupt, the device tries to boot with the backup
Comware software images. If the attempt still fails, the device displays a failure message.

Running the Comware software

To run the Comware software after completing all operations, enter 1 in the EXTENDED-BOOTWARE
menu.
Enter your choice(0-9): 1
Loading the main image files...
Loading file flash:/10500-cmw710-system-R7169P01.bin........................
............................................................................
............................................................................
.........................Done.
Loading file flash:/10500-cmw710-boot-R7169P01.bin..........................
....Done.
Image file flash:/10500-cmw710-boot-R7169P01.bin is self-decompressing......
....................................................Done
System image is starting...
Line aux1 is available.
Press ENTER to get started.

Upgrading Comware software through the console port

You can upgrade the Comware software through the console port or modify the baud rate of the console
port from the Serial submenu.
To upgrade the Comware software through the console port from the Serial submenu:
1. Enter 2 in the EXTENDED-BOOTWARE menu to access the Serial submenu.
===========================<Enter Serial SubMenu>===========================
|Note:the operating device is flash
|<1> Download Image Program To SDRAM And Run
|<2> Update Main Image File
|<3> Update Backup Image File
|<4> Download Files(*.*)
|<5> Modify Serial Interface Parameter
|<0> Exit To Main Menu
============================================================================
image."
253
"Changing the file
|
|
|
|
|
|
|