HP 10500 Series Configuration Manual page 266

Option
<0> Exit To Main Menu
2. Enter 5 in the Ethernet submenu to configure file transfer settings.
Enter your choice(0-5):5
==========================<ETHERNET PARAMETER SET>==========================
|Note: '.' = Clear field.
| '-' = Go to previous field.
| Ctrl+D = Quit.
============================================================================
Protocol (FTP or TFTP) :FTP
Load File Name
Target File Name
Server IP Address
Local IP Address
Subnet Mask
Gateway IP Address
FTP User Name
FTP User Password
Table 24 Setting Ethernet parameters for file transfer
Field
'.' = Clear field
'-' = Go to previous field
Ctrl+D = Quit
Protocol (FTP or TFTP)
Load File Name
Target File Name
Server IP Address
Local IP Address
Subnet Mask
Gateway IP Address
FTP User Name
FTP User Password
Task
Return to the EXTENDED-BOOTWARE menu.
:10500.ipe
:
:10500.ipe
:
:172.1.88.125
:172.1.88.22
:0.0.0.0
:0.0.0.0
:lhw
:***
Description
Press the dot (.), and then press Enter to clear the setting for a field.
Press the hyphen (-), and then press Enter to return to the previous
field.
Press Ctrl+D to exit the Ethernet parameter settings menu.
Set the file transfer protocol to FTP or TFTP.
Set the name of the file to be downloaded.
Set a file name for saving the file in the current storage medium on
the device.
By default, the target file name is the same as the source file name.
Set the IP address of the FTP or TFTP server.
Set the IP address of the device.
Set the IP address mask.
Set a gateway IP address if the device is on a different network
than the server.
Set the username for accessing the FTP server. This username must
be the same as configured on the FTP server. This field is not
available for TFTP.
Set the password for accessing the FTP server. This password must
be the same as configured on the FTP server. This field is not
available for TFTP.
256
|
|
|