Troubleshooting - Wexiodisk WD-6 Installation And User Manual

Instructions for use
PROBLEM
The machine will not start.
The machine does not fill with
water.
The machine fills slowly.
The machine does not stop
filling.
The machine does not start
washing.
Noise from the wash pump.
The machine stops in the
middle of the washing cycle
and starts taking in water.
The machine is not cleaning
properly.
The items are tipped over in
the baskets.
The washed items do not dry.

Troubleshooting

The following errors can be dealt with by the operator. If the problem persists,
contact the service personnel.
CAUSE
The mains switch is off.
The incoming water stopcock is closed.
The hood is open.
The level pipe is not in place.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
The rinsing pipe nozzles are blocked.
The rinsing pipe nozzles are blocked.
The level pipe is not in place.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
The hood is open.
Dishes are blocking the magnet on the
hood/door.
Low water level. Foam in the tank.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
The rinse and wash nozzles are clogged
with dirt.
There is too little detergent.
The water in the tank is too dirty.
Foam forming in tank.
Programme with too short a washing
time selected.
Dirt has dried on the items to be
washed.
The items are incorrectly positioned in
the baskets.
The items are incorrectly positioned in
the baskets.
Light items need washing.
The rinse nozzles are blocked.
Too little rinsing agent.
The washed items have been left in the
machine.
WD-6
ACTION
Turn on main switch
Open the stopcock.
Close the hood.
Fit the level pipe.
Adjust the level pipe. Check that the rub-
ber sleeve has not been damaged.
Change the rubber sleeve if it is dam-
aged.
Clean the rinsing nozzles.
Clean the rinsing nozzles.
Fit the level pipe.
Adjust the level pipe. Check that the rub-
ber sleeve has not been damaged.
Change the rubber sleeve if it is dam-
aged.
Close the hood.
Remove the dishes.
Check the level. Change the water.
Adjust the level pipe. Check that the rub-
ber sleeve has not been damaged.
Change the rubber sleeve if it is dam-
aged.
Check and clean the nozzles.
Check the amount of detergent. The
hose must be submerged in liquid and
the filter in the hose must be clean.
Change the water.
Check that the washing temperature is
not too low and that the correct deter-
gent is being used.
Choose a programme with a longer
washing time.
Soak the items before washing.
Use the right type of washing basket and
accessories so that the items are cor-
rectly positioned.
Put the items in the correct position.
Use a net grid to hold the items.
Check and clean the nozzles.
Check the amount of rinsing agent. The
hose must be submerged in liquid and
the filter in the hose must be clean.
Remove the washed items once the pro-
gramme has ended.
44
Rev. 4,0 (201302)