Table of Contents
Advertisement
Directions for use
4.3.6 Operational disturbances
Troubleshooting
The following errors can be dealt with by the operator. If the problem persists,
contact responsible service personnel.
PROBLEM
The machine does not start.
The machine does not fill with
water.
The machine is filling slowly.
Filling does not stop.
Machine will not start wash-
ing.
Noise from wash pump.
The machine stops in the
middle of the washing cycle
and starts taking in water.
The machine is not cleaning
properly.
Dishes upset in the baskets.
Washed items won't dry.
WD-4C
CAUSE
Main switch off.
Shut-off cock for incoming water is
closed.
The door is open.
Level pipe not in place.
The level pipe's rubber seal is not
sealing against the bottom plate.
The rinsing pipes' nozzles are
blocked.
The rinsing pipes' nozzles are
blocked.
Level pipe not in place.
The level pipe's rubber seal is not
sealing against the bottom plate.
The door is open.
Dishes are blocking the magnet on
the hood/door.
Low water level. Foam in tank.
The level pipe's rubber seal is not
sealing against the bottom plate.
Rinse and wash nozzles clogged
with dirt.
Too little detergent.
Water in tank too dirty.
Foam forming in tank.
Dirt has dried on items.
Items incorrectly positioned in bas-
kets.
Items incorrectly positioned in bas-
kets.
Light items need washing.
Rinse nozzles clogged.
Too little rinsing agent.
The washing has been left in the ma-
chine.
26
Rev. 3.0 (201308)
ACTION
Turn on main switch
Open cock.
Close the door.
Fit level pipe.
Adjust the level pipe. Check that the rub-
ber seal has not been damaged.
Change damaged rubber seal.
Clean the rinsing nozzles.
Clean the rinsing nozzles.
Fit level pipe.
Adjust the level pipe. Check that the rub-
ber seal has not been damaged.
Change damaged rubber seal.
Close the door.
Remove the dishes.
Check level. Change water.
Adjust the level pipe. Check that the rub-
ber seal has not been damaged.
Change damaged rubber seal.
Check and clean nozzles.
Check the amount of detergent. The
hose must be submerged in liquid and
the filter in the hose must be clean.
Change water.
Check that the washing temperature is
not too low and that the correct deter-
gent is being used.
Soak items before washing.
Use the right type of washing basket and
accessories for the correct placement of
items.
Reposition items.
Use a net grid to hold utensils.
Check and clean nozzles.
Check the amount of rinsing agent. The
hose must be submerged in liquid and
the filter in the hose must be clean.
Remove the washed items once the pro-
gram has ended.
Hide quick links:
Advertisement
Table of Contents
