Electrical Connection; Water Connection, Regardless Of Any Options - Wexiodisk WD-59CTS Installation And User Manual

Installation instructions

3.6.3 Electrical connection

3.6.4 Water connection, regardless of any options

WD-59CTS & WD-66CTS
Information about electrical connections (1 or 2) is available on the machine's
wiring diagram which is provided on delivery. Store the diagrams in the plastic
pocket, located in the electrical cabinet, even after installation.
It is important that the electrical connection is checked so that it is certain that the
live and neutral wires are correctly connected and not swapped over. It is also
important to check at the same time that the earthing system connection is correct
and sufficient so that the machine's electrical and personal security system is not
compromised.
• The machine is designed for quick electrical installation.
• The machine has a built-in main switch.
• An earth cable for potential equalisation is connected to the earth bolt (A)
on the stand.
Positioning of earth bolt
A = Earth bolt
After completing the installation, switch on the main switch and all circuit
breakers.
• A shut-off cock must be installed on the incoming lines.
• The machine is equipped with a break-tank including booster pump as
standard to obtain the correct flow of water to the machine. The required
water flow and
SPECIFICATIONS.
Connect the cold and hot water pipes according to the labels by the connection
points (3, 4). If the machine is connected with a hose, this should be steel braided
and have an internal diameter of at least 12 mm.
The hot water connection on the machine is fitted with a filter.
The cold water connection on the machine is fitted with a filter, non-return valve
and Break tank.
pressure can be
21
Rev. (202210)
A
66CT_T_11
found in the TECHNICAL