Table of Contents
Advertisement
Installation
3.7.9 Electrical connection
This symbol on a machine component warns of the presence of electrical equip-
ment. The component may only be removed by a qualified electrician. The ma-
chine is sensitive to electrostatic discharge (ESD), which is why a static electricity
wristband must be used when handling the electronics.
Information about electrical connections can be found on the machine's wiring di-
agrams. The wiring diagrams are shown on the inside of the electrical cabinet
door. Store the diagrams in the electrical cabinet after installation.
The machine has a built-in main switch. Rating data is given on the rating plates,
which are located on the end of the outfeed and in the electrical cabinet. Electrical
data is also shown on the machine's wiring diagram. The installation diagram
shows the location of the electrical connection.
The various fields on the rating plate show:
1.
Machine type
2.
Machine serial number
3.
Year of manufacture
4.
Enclosure protection class
5.
Voltage
6.
Number of phases, with or without zero
7.
Frequency
8.
Main fuse
9.
Motor output
10.
Electrical heating output
11.
Max. output
Wexiödisk AB
Type
1
No
3
2
5
6
Hz
V
7
9
kW
10
M
Mårdvägen 4, S-352 45 V ÄXJÖ SWEDEN
Rating plate
An earth cable for potential equalisation is connected to the earth bolt (B) on the
stand. The connection is located on the beam in front of the heat exchanger (A).
WD-59CT & WD-66CT
IP
4
A
8
11
kW
kW
marks_07
20
Rev. 2.0 (20110124)
Advertisement
Table of Contents
